还是那个基准源LM399,需要输出到1.25V,使用AD8676相当于是跟随了一下。结果输出的电压是分压的电压,但是监视精度时发现噪声明显的大。还对照了以前的设计,没觉得有什么问题呀。
我甚至开始怀疑两次改版直接将2层板改为4层板引入了噪声。经过一天的对比测试,突然想到上次调试时好像有电压太低时电压都不对的情况,是不是不支持轨到轨?于是把分压调大到2.5V(后端的单端转差分改为一倍放大,跟随...
在Altium Designer中使用多通道room功能时,元件默认有很长的通道名称,这如果显示在板子上绝对会疯掉。所以有个简要的方式变短元件名。
Pro...
最近在使用LM399在做基准源,发现按照手册上的结构该一个标准1V的基准时出现问题,LM399的输出比标准电压笑了,而且波动很大。后来发现是用的分压电阻总电阻太小,小于14K了。但手册明明说电流在0.5mA~10mA区间都是可靠区域,但是就是不准,很奇怪。
把分压电阻调整绝对值,保持比例,问题就解决了。目前电流应该小于0.5mA。
后来发现个问题,我的启动电阻有7.5K,如果我分压电阻太小了...
安装参考这个连接,建议明确的先创建一个专用用户,然后再安装。参考连接最好的地方就是说了开机自启动问题,不过它没写反向链接的问题。由于我自己使用了宝塔面板,...
Office 2007/2010:
Outlook 选项 -> 高级 -> 国际选项
这样回信时就会自动使用英文的Re,FW啥的了。
reg [19:0] clk_counter;
reg [0:19] clk_counter;
这两个定义竟然完全不一样,结果我使用clk_couter[...